IBM 42M5861 Internal UPS 300W Low Voltage Power Supply for SureP

IBM 42M5861 Internal UPS 300W Low Voltage Power Supply for SurePOS 700 Low Voltage 42M5877 23K8051
FRU Part # 42M5861
Condition: New - Tested - Can not gaurantty if batter is holding enough charge as battry may or may not good
Customer responsibility to replace the battery if it is not good - plastic covers need to be removed and retention bracket with thumb screw needs to be removed to get the UPS out
and replace the battery.
Content: one Power Supply only

Please Note :
This item present here forUSA and Canadian Buyers only.
If you are located out side of USA / Canada then please you must need to payExtra shipping charges.

Interface Port Female DB-9 RS232
AC Input (1) IEC 320 male
AC Output (3) IEC 320 female
On/Off control Switch On / Off control for UPS and SP700 when properly configured
Mode DIP Switches (2) DIP switches to select operation mode (see below)
Circuit Protection Reset button on rear of UPS
Status Indicators Green Status LED (front)
AC Power Solid green
Battery Mode Blinking slowly (2 Hz)
Low Battery Blinking rapidly (6 Hz)
Typical recharge time is 8 hours
Due to safety regulations, the battery may be shipped disconnected. Once you receive the UPS, you must connect the battery terminals, and fully charge the battery prior to use.
The UPS is rated as a 500VA / 300W UPS. Battery duration will depend on POS configurations.
The UPS is also supported on 4690 V3R3 or later.

More Info

Weight: 4.3Kgs.
Dimension: 15 x 4.25 x 3.1 inch approx.

To use with: SurePOS 700 Low Voltage (Optional, Wide Systems Only)

Information's are here for your reference only and accuracy can not be guaranteed.

Copyright 2012 All rights reserved